1 # This is an NUCLEO-L053R8 board with a single STM32L053R8Tx chip
\r
3 # Generated by System Workbench for STM32
\r
4 # Take care that such file, as generated, may be overridden without any early notice. Please have a look to debug launch configuration setup(s)
\r
6 source [find interface/stlink.cfg]
\r
8 set WORKAREASIZE 0x2000
\r
10 transport select "hla_swd"
\r
12 set CHIPNAME STM32L053R8Tx
\r
13 set BOARDNAME NUCLEO-L053R8
\r
16 set CHIPNAME_CPU0_ACTIVATED 1
\r
18 # Enable debug when in low power modes
\r
19 set ENABLE_LOW_POWER 1
\r
21 # Stop Watchdog counters when halt
\r
24 # STlink Debug clock frequency
\r
27 # use hardware reset, connect under reset
\r
28 # connect_assert_srst needed if low power mode application running (WFI...)
\r
29 reset_config srst_only srst_nogate connect_assert_srst
\r
30 set CONNECT_UNDER_RESET 1
\r
32 # BCTM CPU variables
\r
36 source [find target/stm32l0x.cfg]
\r